Placard Tabloc Straps: How to Secure Your Chest Rig Setup
By Haley Strategic Partners | Published: 2026-10-31
Category: How-to Guides
Learn how to attach Placard Tabloc Straps to your Thorax Incog Plate Carrier for a secure, buckle-free placard setup. Step-by-step routing and checkpoint tips.
Quick answer
To secure your chest rig setup, route the Placard Tabloc Straps through the compatible slots on your MOD Placard and the Thorax Incog Plate Carrier's TABLOC system, then tension and lock them down. This replaces protruding buckles and MOLLE weaving with a rapid, low-profile attachment.
Why Tabloc straps instead of buckles or MOLLE
Traditional placard attachment often involves threading MOLLE webbing or using side-release buckles that can snag and add bulk. The Tabloc system is designed to eliminate those protruding parts while still allowing quick detachment. However, it requires a compatible plate carrier—specifically the Thorax Incog—and a placard from the MOD Placard Family. If you run a different carrier or placard, these straps won't work.
When to expect a tighter or looser fit
The straps are made from flexible material, so tensioning affects how tightly the placard sits against the carrier. A very tight setup minimizes movement but can make reindexing magazines slightly stiffer. A looser setup is easier to manipulate but may allow the placard to shift during vigorous movement. Adjust according to your preference and mission.
Step-by-step Tabloc strap installation
- Prepare your placard and carrier: Lay your Thorax Incog Plate Carrier face-up and identify the TABLOC attachment points. Have your MOD Placard ready with the rear facing you. Remove any existing buckles or MOLLE accessories from both surfaces. Checkpoint: Ensure the carrier is the Thorax Incog model; other carriers lack TABLOC slots.
- Route the first strap: Take one Placard Tabloc Strap and feed the end through the top slot on the placard, then through the corresponding TABLOC slot on the carrier. Pull the strap through until the tab locks into place. Common mistake: forcing the strap through a wrong-sized slot can damage the tab. Match slot shapes.
- Route the second strap: Repeat the routing process for the second strap on the opposite side, ensuring both straps are oriented symmetrically and the tabs face outward for easy access. Checkpoint: Both straps should have equal length extending from the placard before tensioning.
- Tension and lock: Pull the free end of each strap to remove slack, then press the tab down firmly to lock it. Adjust tension so the placard sits snug against the carrier but can still be removed with deliberate force. Common mistake: over-tightening can make the placard difficult to detach; test by pulling gently.
- Verify security: With the placard attached, grasp it and attempt to rock it side-to-side and pull it away from the carrier. The straps should hold without releasing or excessive movement. Checkpoint: If the placard shifts more than a few millimeters, re-tension the straps.
Product facts
- Placard Tabloc Straps - Black: Enables integration of the MOD Placard Family into the TABLOC system of the Thorax Incog Plate Carrier without protruding buckles or MOLLE weaving. This means you get a faster, lower-profile attachment that reduces snag hazards and simplifies setup.
Placard Tabloc Straps - Black - Placard Tabloc Straps - Black: Made in the USA from USA materials (Berry Compliant). You can trust the materials meet strict quality and sourcing standards for durability in the field.
