Incog X 槍套 Staccato CS/C2/P 含 Mag Caddy：設定與使用

Quick answer

Set up your Incog X holster for Staccato CS, C2, or P with the Mag Caddy by adjusting the belt clips for your preferred carry position, setting the retention screw for a secure draw, and confirming the weapon light fit if applicable.

Step-by-step setup guide

1. 1. Choose your carry position: Decide between appendix (AIWB) or strong-side hip. The Incog X's multi-positional clips allow you to adjust the cant and ride height. For appendix carry, set the clips to a slight forward cant (about 10 degrees) for better concealment. Common mistake: Setting the cant too far forward can cause the grip to print. Start with a neutral cant and adjust 2 degrees at a time.
2. 2. Set the retention screw: Locate the retention screw on the holster body. Use a #2 Phillips driver to adjust the tension. Tighten until the holster holds the pistol securely but allows a smooth draw. For Staccato CS/C2, start with the screw flush with the body and test. Checkpoint: After adjusting, holster and unholster the pistol 10 times. If it feels too tight or too loose, adjust in quarter-turn increments.
3. 3. Attach the Mag Caddy: The Mag Caddy mounts to the holster via two screws on the side. Align the caddy so the magazine sits at the same angle as the pistol grip. Tighten the screws firmly but avoid over-tightening, which can strip the threads. Common mistake: Mounting the caddy too high can cause the magazine to dig into your ribs. Keep the top of the magazine level with the top of the holster body.
4. 4. Adjust the belt clips: The Incog X includes two belt clips that can be moved between multiple slots. For appendix carry, place one clip at the 12 o'clock position and the other at 2 o'clock (if using the Mag Caddy) or 3 o'clock (without). This distributes the weight evenly. Checkpoint: Wear the holster for 5 minutes and check for hot spots. If the caddy presses into your thigh, move the rear clip one slot outward.
5. 5. Test with your draw stroke: With an unloaded pistol, practice drawing from the holster 10-15 times. Focus on a smooth, straight pull. The Incog X's hybrid design (leather backer, Kydex front) should release cleanly. If the pistol sticks, check the retention screw or clip alignment. Common mistake: A jerky draw often means the holster is riding too low. Raise the ride height by moving the clips to a higher slot.

Product facts

• Incog X Holster Staccato CS/C2/P Weapon Light w/ Mag Caddy: The Incog X Holster is the latest evolution in ergonomic, RDS compatible, multi positional, deep concealment IWB hybrid holsters, designed with Safariland. This means you can carry your Staccato with a red dot and weapon light without switching holsters, and adjust the carry position to appendix or strong-side.